Installation precautions – Nikon LS-10 Installation Guide for Windows User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Chapter 2
Setting Up Coolsran
Installation Precautions
The following guidelines should be observed when installing Coolscan:
1. Make certain that power to all instruments directly connected to Coolscan (via
SCSI) is turned off before beginning the installation. This includes the AC power
switch on Coolscan (LS-lOE only).
If you are installing an LS-10, there is no AC power switch since it relies on the PC’s
power. Therefore, make sure that the PC’s power is off
2. Turn off the power to all peripherals connected to the computer (display, printer,
etc.).
3. If your PC has a key-lock facility, turn the key to the unlock position.
4. Unplug the AC power cable to the PC.
5. When mounting Coolscan into the PC (LS-10 only), be especially mindful to
eliminate electrostatic discharge, as it can damage the scanner.
Electrostatic discharge will damage the scanner if you touch its SCSI connector
pins. Do
not
touch the pins.
Nikon
Coolscan Installation Guide for Windows
Page 13