Nikon LS-10 Installation Guide for Windows User Manual

Page 53

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Mounting the LS-10

Chapter 4

Once the scanner is pushed into the computer, reposition or reinsert the lock tabs

dealt with in Step 6, Procedure 4,1. The tabs should slide in front of the scanner guide

rails thereby locking the scanner in place.

Step 7. Repl acc the computer’s cover.

Replace the computer’s cover making sure not to cut, pinch or bend any internal

cables.

Step 8. Reconnect the monitor.

Step 9. Reconnect the computer’s AC power cord.
Step 10. Start the PC.

Start up the PC in the usual way. Your disk drive should boot within a few sec

onds. If your PC does not start up as it normally does, or if Coolscan’s

power/busy/error LED indicator is not lit or continuously blinking, refer to the

“Troubleshooting” chapter in this manual.

Page 46

Nikon

Coolscan Installation Guide for Windows