Dell PowerEdge T605 - Manual (Page 33)

About Your System
33
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
Table 1-6. System Messages
Message Causes Corrective Actions
Alert! Redundant
memory disabled!
Memory
configuration
does not support
redundant
memory.
Redundant memory was set
to enable in CMOS, but the
current configuration does
not support redundant
memory. See "General Memory
Module Installation
Guidelines" on page 128 for
memory configuration
information. If the problem
persists, see
"Troubleshooting System
Memory" on page 173.
Alert!
Redundancy was
previously lost.
Power cycle
required to
reconfigure
redundant
memory.
A spare rank event occurred
during the previous boot. See "General Memory
Module Installation
Guidelines" on page 128 for
memory configuration
information. If the problem
persists, see
"Troubleshooting System
Memory" on page 173.
Attempting to
update Remote
Configuration.
Please wait...
Remote Configuration
request has been detected
and is being processed. Wait until the process is
complete.
BIOS Update
Attempt Failed!
Remote BIOS update
attempt failed. Retry the BIOS update. If
problem persists, see
"Getting Help" on page 205.
Caution!
NVRAM_CLR jumper
is installed on
system board.
NVRAM_CLR jumper is
installed. CMOS has been
cleared. Remove NVRAM_CLR
jumper (see Figure 6-1 for
jumper location).
Decreasing
available memory
Faulty or improperly installed
memory modules. See "Troubleshooting System
Memory" on page 173.