Dell PowerEdge T605 - Manual (Page 112)

112
Installing System Components
9 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card’s cable
connections.
10 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
11 Close the system. See "Closing the System" on page 70.
12 Place the system upright and on its feet on a flat, stable surface.
13 Reattach any peripherals, then connect the system to the electrical outlet.
14 Turn on the system and attached peripherals.
15 Install any device drivers required for the card as described in the
documentation for the card.
SAS Controller Card
Your system can have an optional SAS controller expansion card that provides
the SAS storage subsystem for your system’s internal or hot-plug (when
available) hard drives. The controller supports either all-SAS or all-SATA hard
drive configurations. The controller also enables you to set up the hard drives
in RAID configurations as supported by the version of the SAS controller
included with your system. Both RAID and non-RAID versions of the
controller are available for your system. A SAS/RAID controller card can only
be installed in its dedicated slot (slot 2) on the system board. See the RAID
user documentation for information on the available RAID configurations
and for instructions on how to set up a RAID.
Installing a SAS Controller Card
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
NOTICE:
When installing a SAS/RAID controller, do not press on the RAID card
DIMM while installing the RAID card into the system board.