Dell PowerEdge T605 - Manual (Page 127)

Installing System Components
127
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Hold the replacement fan with the fan cable on the left side (opposite of
the power supply), and align the edges of the fan with the securing slots.
2 Slide the fan left into the securing slots until the fan release tab locks into
place. See Figure 3-32.
3 Connect the cable to the FAN_2 connector on the system board (see
Figure 6-1 for the connector location).
4 Install the processor shroud. See "Installing the Processor Shroud" on
page 74.
5 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
6 Close the system. See "Closing the System" on page 70.
7 Place the system upright and on its feet on a flat, stable surface.
8 Reattach any peripherals, then connect the system to the electrical outlet.
9 Turn on the system and attached peripherals.