Dell PowerEdge T605 - Manual (Page 139)

Installing System Components
139
6 Install the processor shroud. See "Installing the Processor Shroud" on
page 74.
7 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
8 Close the system. See "Closing the System" on page 70.
9 Place the system upright and on its feet on a flat, stable surface.
10 Reattach any peripherals, then connect the system to the electrical outlet.
11 Turn on the system and attached peripherals.
As the system boots, it detects the presence of the new processor and
automatically changes the system configuration information in the System
Setup program.
12 Press to enter the System Setup program, and check that the processor
information matches the new system configuration. See "Entering the
System Setup Program" on page 43.
13 Run the system diagnostics to verify that the new processor operates
correctly.
See "Running the System Diagnostics" on page 193 for information about
running the diagnostics.
System Battery
The system battery is a 3.0-volt (V), coin-cell battery.
Replacing the System Battery
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
CAUTION:
There is a danger of a new battery exploding if it is incorrectly
installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See your System Information Guide for additional information.