Dell PowerEdge T605 User Manual
Page 155
Installing System Components
155
2 Open the system. See "Opening the System" on page 68.
3 Remove the expansion card shroud. See "Removing the Expansion Card
4 Remove the processor shroud. See "Removing the Processor Shroud" on
5 Depending on your configuration, disconnect the following cables from
the system board. See Figure 6-1 for connector locations.
•
Three power-supply cables from the PWR1, PWR2, and PWR3
connectors
•
I/O panel cable from the
CTRL_PNL
connector
•
SATA cable(s) from the SATA connector(s)
•
Diskette data cable from the FLOPPY connector
•
PATA data cable from IDE connector
•
Expansion card fan cable from the FAN1 connector
•
System fan cable from the FAN2 connector
•
SAS LED cable from the PERC_LED connector
•
SAS/SATA backplane cable from BP_12C connector
•
Intrusion switch cable from the INTRUSION connector
6 If applicable, remove all expansion cards and any attached cables. See
"Removing an Expansion Card" on page 108.
7 If applicable, remove the RAC card. See "Removing the RAC Card" on
8 If applicable, remove the SAS controller card. See "Removing a SAS
9 Remove the internal USB memory key, if present. See Figure 6-1 for the
USB socket location.
10 Remove the TOE hardware key, if present. See Figure 6-1 for the
TOE_KEY socket location.
11 Remove all memory modules. See "Removing Memory Modules" on
NOTE:
Record the memory-module socket locations to ensure proper
reinstallation of the memory modules.