Dell PowerEdge T605 - Manual (Page 115)

Installing System Components
115
11 For battery-cached SAS/RAID controllers, install the RAID battery. See
"Installing a RAID Battery" on page 116.
12 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
13 Close the system. See "Closing the System" on page 70.
14 Place the system upright and on its feet on a flat, stable surface.
15 Reattach any peripherals, then connect the system to the electrical outlet.
16 Turn on the system and attached peripherals.
Removing a SAS Controller Card
1 Disconnect the SAS cable, LED cable, and RAID battery cable (if
applicable) from the SAS controller card.
2 Grasp the card by its top corners and ease it out of its connector. See
"Removing an Expansion Card" on page 108.
3 If you are removing the card permanently, install a filler bracket in the
empty card slot.
NOTE:
Filler brackets must be installed over empty expansion card slots to
maintain Federal Communications Commission (FCC) certification of the
system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
4 If applicable, remove the RAID battery from the battery holder. See
"Installing and Removing a RAID Battery" on page 117.
RAID Battery
The information in this section applies only to systems with the optional
battery-cached SAS controller card.