Dell PowerEdge T605 - Manual (Page 12)

12
About Your System
• Updates are sometimes included with the system to describe changes to
the system, software, and/or documentation.
NOTE:
Always check for updates on support.dell.com and read the updates
first because they often supersede information in other documents.
• Release notes or readme files may be included to provide last-minute
updates to the system or documentation or advanced technical reference
material intended for experienced users or technicians.
Accessing System Features During Startup
Table 1-1 describes keystrokes that may be entered during startup to access
system features. If your operating system begins to load before you enter the
keystroke, allow the system to finish booting, and then restart your system
and try again.
Table 1-1. Keystrokes for Accessing System Features
Keystroke Description
Enters the System Setup program (see "Entering the System Setup
Program" on page 43).
Opens the utility partition, allowing you to run the system diagnostics
(see "Running the System Diagnostics" on page 193).
Enters the boot mode selection screen, allowing you to choose a boot
device.
Starts PXE boot.
Enters the Baseboard Management Controller (BMC) Management
Utility, which allows access to the system event log (SEL) and
configuration of the remote access controller (RAC) card (see the BMC
User’s Guide for more information on setup and use of BMC).
This keystroke enters the SAS Configuration Utility (see your SAS
controller User’s Guide for more information).
If you have the optional battery-cached SAS RAID controller, this
keystroke enters the RAID configuration utility. For more information,
see the documentation for your SAS controller card.