Dell PowerEdge T605 - Manual (Page 177)

Troubleshooting Your System
177
2 Run the appropriate online diagnostic test. See "Using Dell PowerEdge
Diagnostics" on page 193.
3 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
4 Open the system. See "Opening the System" on page 68.
5 Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
6 Ensure that the diskette drive interface cable is securely connected to the
diskette drive and the system board.
7 Ensure that a power cable is properly connected to the drive.
8 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
9 Close the system. See "Closing the System" on page 70.
10 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
11 Run the appropriate online diagnostic test to see whether the diskette
drive works correctly.
If the problem persists, continue with the following steps.
12 Turn off the system and attached peripherals, and disconnect the system
from its electrical outlet.
13 Open the system. See "Opening the System" on page 68.
14 Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
15 Remove all expansion cards installed in the system. See "Removing an
Expansion Card" on page 108.
16 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
17 Close the system. See "Closing the System" on page 70.
18 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
19 Run the appropriate online diagnostic test to see whether the diskette
drive works correctly.