Dell PowerEdge T605 - Manual (Page 187)

Troubleshooting Your System
187
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3 Open the system. See "Opening the System" on page 68.
4 Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
5 Ensure that each expansion card is firmly seated in its connector. See
"Installing an Expansion Card" on page 111.
6 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
7 Close the system. See "Closing the System" on page 70.
8 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
If the problem persists, go to the next step.
9 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
10 Open the system. See "Opening the System" on page 68.
11 Remove the expansion card shroud. See "Removing the Expansion Card
Shroud" on page 72.
12 Remove all expansion cards in the system. See "Removing an Expansion
Card" on page 108.
NOTE:
If your operating system is running off a disk controller card (such as a SAS
controller card), do not remove it.
13 Install the expansion card shroud. See "Installing the Expansion Card
Shroud" on page 75.
14 Close the system. See "Closing the System" on page 70.
15 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
16 Run the appropriate online diagnostic test.
If the tests fail, see "Getting Help" on page 205.
17 For each expansion card you removed in step 12, perform the following
steps: