Bio-Rad Image Lab™ Software - Manual (Page 165)

Recalibrating Your Imager
User Guide | 165
2. The software prompts you to restart the calibrations needed for the new
illumination sources.
3. Click OK to exit the dialog box. Your settings persist until you make further
changes.
Note: If the Gel Doc XR+ and ChemiDoc XRS+ systems are used to conduct
quantitation with Bio-Rad’s stain-free gel technology, Bio-Rad recommends
performing the flat field calibration with the orange fluorescence reference plate
(catalog # 170-8008) after installing Image Lab 5.1. For instructions on
performing this calibration, see Calibrating the Imager to Use the Orange
Fluorescence Reference Plate on page 218 .