Unitec Wash Select II POS Owner’s Manual - Manual (Page 86)

W A S H S E L E C T I I
Document Number: WS21002 72
Document Title: WSII Operations Manual
D I S P E N S E M O D E 2 : ( A N Y T I M E )
The Wash Select II will refund any money that has not yet been applied to the purchase of a
wash.
Follow these steps to configure the dispense mode:
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the ”Cash & Tokens” option is displayed. Press the (*) key to
enter.
3.
Using the (3) key scroll through this menu until the “Dispense Mode” option is
displayed, and then press the (*) key to enter.
4. Enter the dispense mode of your choice (0-2), and then press the (*) key.
Default: Dispense Mode 1
2.11.5 Configure Dispensed Coin Value
This function allows you to configure the value of the coin that is dispensed (given as
change). If you wish to dispense the $1 coin, you must first modify the hopper to allow for the
larger coin. The steps below will assist you with setting the “Dispensed Coin Value”.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the ”Cash & Tokens” option is displayed. Press the (*) key to
enter.
3.
Using the (3) key scroll through this menu until the “Dispense Value” option is
displayed, and then press the (*) key to enter.
4. Enter the desired value in cents format, and then press the (*) key. (Example: A
value of $.25 must be entered as 25.)
2.11.6 Disabling Cash Acceptance
You may disable the acceptance of cash at the Wash Select II unit. If you set the system to
“No Cash Mode”, you will not see or print the cash-related sections of the accounting and
configuration reports. To enter “No Cash Mode”:
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the ”Cash & Tokens” option is displayed. Press the (*) key to
enter.