Unitec Wash Select II POS Owner’s Manual - Manual (Page 80)

W A S H S E L E C T I I
Document Number: WS21002 66
Document Title: WSII Operations Manual
Setting Description
Termination Characters
(up to 10 digits)
Optional. Set to 0 if not needed.
If your system requires you to enter a series of options to send the
message or set the priority, then add those here. The termination
characters will be sent after the tone message is sent. For example
if you have to press # when finished, and then you have to press 1
to send the page you would enter:
# , 1
The comma will add a 2 second pause after the #
Use the following procedure to program or edit the pager number:
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the ”Paging Functions” option is displayed. Press the (*) key to
enter.
3.
Scroll through this menu until the “Edit Pager #” option is displayed, and then
press the (*) key to enter.
4. Enter a slot number (1-6). Press the (*) key to enter.
5. Enter a pager type. 1 = Voice, 2 = Numeric, and 3 = Text. Press the (*) key to
enter.
6. Ent er the pager’s telephone number including the area code, if it is necessary for
the modem to dial a 1 you must enter that as well. Example: 15555551212. Press
the (*) key to enter.
7. Enter the pause to answer 0-120 seconds, and then press the (*) key to enter.
8. Enter your PIN number, and then press the (*) key.
9.
Enter the “Termination Chrs.”, and then press the (*) key to enter. (Refer to the
table above for setting descriptions.)
2 . 1 0 . 3 . 3 T e x t ( T a p ) P a g e r S e t t i n g s D e s c r i p t i o n
The Text Pager option allows you to receive more detailed text messages.