Unitec Wash Select II POS Owner’s Manual - Manual (Page 76)

W A S H S E L E C T I I
Document Number: WS21002 62
Document Title: WSII Operations Manual
2.10.2 Pager Error Codes
The following table provides a listing of each of the alarm conditions and error codes
generated for each type of pager supported by the Wash Select II.
Table 7. Pager Error Codes
Error
Code #
(Numeric)
Text Name
(Text/TAP)
Detailed Description Problem
Type
Priority
(Voice/
Tone)
Lower
Tolerance
Upper
Tolerance
1 HOPPER LOW Hopper low-level sensor
detected an absence of
quarters. This also occurs if
hopper
is unplugged.
Detected when unit is idle
Warning 2 1 1
2 HOPPER
JAM/EMPTY Hopper failed to dispense a
customer change. Amount
will
show up in
overpayments.
Warning 2 1 2
3 WASH WARNING Wash Warning signal input
activated Warning 2 1 5
4 WASH OUT-O-
SERV Wash Out of Service signal
detected on Wash in Use
input Fault 3 1 5
5 WASH TIMEOUT Wash was armed but the
wash in use signal was not
detected within 10 minutes. Warning 1 2 5
6 CREDIT ERROR System rejected several
cards due to a credit
network problem Warning 1 3 4
7 CASH FRAUD System registered cash
after
the cash was
disabled. Possible salting
or stringing attempt.
Warning 1 2 3
8 PRINTER PAPER Printer Paper is out Warning 2 1 2
9 PRINTER PWR
ERR No 24VDC power to printer Warning 2 1 2
10 PRINTER ERROR Printer is either
disconnected,
malfunctioning, or paper
head arm is disengaged.
Warning 2 1 2
11 BILL JAM A bill is jammed in the bill
validator. Warning 2 1 1
12 BILL STACKER
FULL The bill stacker needs to be
emptied. Warning 2 1 1
13 BILL FAILURE The bill validator has failed. Warning 2 1 1