Unitec Wash Select II POS Owner’s Manual - Manual (Page 71)

W A S H S E L E C T I I
Document Number: WS21002 57
Document Title: WSII Operations Manual

Security Code: used to decrypt the wash code and is up to 7 digits. Using default value
or simple numbers like “1234567” or “3333333” is discouraged.
Note: After completing the items, the settings are printed out. Keep printout as the same
settings are entered into the POS4000(s).
For any Secondary Units connected to the Primary unit and using remote code, enable
Remote Code on that unit too. However, no parameters need to be programmed on those
units.
2 . 8 . 1 2 . 2 R e m o t e C o d e U t i l i t i e s
To access the Remote Code utilities, go to the Wash Interface menu.

Print Used Codes: Get a printout of the redemption of the codes sold on a
particular day. Enter the date when the code issue date in the MMDD format
(leading 0 required), then press ‘*’. Codes redeemed in any secondary units
connected are included too.

Clear Used Codes: To clear the code redemption history.
2 . 8 . 1 2 . 3 C h a n g e s t o C o d e E n t r y o n W a s h S e l e c t I I
When Remote Code is enabled, these features apply to all codes entered in the WSII
keypad:

DO NOT use 6 or 7 digit codes for fleet accounts when using Remote Code. The
Code Length may conflict with codes sold at the Remote Code POS4000.

Zeros in code no longer serve as the Enter key, it can appear in any position for
any code.

Fleet Account codes which have less than 5 digits will require the * key to enter
the code. Although the code still requires the 0 at the end during setup, the 0 no
longer acts like the Enter key
– you must press *. If you enter a fleet code less
than 5 digits and do not press *, the screen eventually resets back to Please
Enter Your Code
– the code is not accepted.

For codes longer than 5 digits, a 3 second pause will cause the code to be
entered automatically
2.9 Customer Interface Menu
The “Customer Interface Menu” contains functions that affect the operation of the coin box
with the customer.
2.9.1 Customer Stacking
This feature allows you to enable or disable the ability for the Wash Select II to interact with a
customer in front of it while the wash is in use.