Unitec Wash Select II POS Owner’s Manual - Manual (Page 43)

W A S H S E L E C T I I
Document Number: WS21002 29
Document Title: WSII Operations Manual
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Scroll through the main menu until the "Credit System" option is displayed. Press
the (*) key to enter.
3. Scroll through this sub- menu, until the “Credit Sales Tax” option is displayed.
Press the (*) key to enter.
4. The unit will ask if you want to enable credit sales tax. Select 1 for Yes or 2 to
Disable and press the (*) key to enter.
5. Enter the amount of tax in percent form (0.00%) and press the (*) key to enter.
2.4 Diagnostics Menu
The Diagnostics menu contains diagnostics functions that are used for troubleshooting and
testing the Wash Select II system components.
2.4.1 Testing Output Relays
In this sub-menu, you may turn each of the Wash Select II outputs on or off. To test the
output relays:
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the "Diagnostics" option is displayed. Press the (*) key to enter.
3. Use the (3) key to scroll until the "Test Outputs" option is displayed. Press the (*)
key to enter. (This should be the first option displayed)
4.
Once you are in the “Test Outputs” menu you may turn the following outputs on
or off, by pressing (1) for YES or (3) for NO. (You may scroll to the next option
using the (3) key.)

Wash Relay 1 – output to car wash controller

Wash Relay 2 – output to car wash controller

Wash Relay 3 – output to car wash controller

Wash Relay 4 – output to car wash controller

Wash Relay 5 – output to car wash controller

Wash Relay 6
– output to car wash controller

Wash Relay 7 – output to car wash controller

Wash Relay 8 – output to car wash controller

Bill Enable – Signal to bill validator (not bill validator power)

Coins Enable – power to coin acceptor

Fault Relay – output to external device such as car wash controller

Warning Relay – output to external device such as car wash controller