Unitec Wash Select II POS Owner’s Manual - Manual (Page 150)

W A S H S E L E C T I I
Document Number: WS21002 136
Document Title: WSII Operations Manual
Setting Effect
Dispense Mode This will affect when a customer may receive
change from the Wash Select II.
Dispense Value This setting will configure the unit to know the
monetary value of each coin dispensed.
Dump Coins In the diagnostic mode, this setting can be used to
dispense a specific number of coins for test.
Coins Present Diagnostic function that detects the presence of
coins in the hopper.
Exact Change Only The Wash Select II will immediately go into an
exact change only mode if it ever attempts to
dispense change unsuccessfully. To clear this
mode, turn the unit power off then on again. It will
clear the next time it successfully dispenses
change.
3.9 Card Reader
The card reader may be used with the Credit option or just for fleet cards and pass cards.
3.9.1 Card Reader Related System Settings
After repeated use, the credit card reader acceptance rate will begin to decline. This is due
primarily to the internal sensing devices becoming soiled. It is best to clean your card reader
using card reader cleaning cards. These cleaner cards may be purchased directly from your
distributor or from the manufacturer of the cleaner cards. The cleaner cards are Unitec stock
#MS2031 and can also be purchased from Clean Team by calling 1-800-888-8830.
3.9.2 System Settings Affecting Card Reader Operations
The following Wash Select II system settings will have an effect on how the Card Reader
operates.
Table 29. Card Reader Related System Settings
Setting Effect
Credit Mode 0 – no credit The card reader will not recognize or try to process
a transaction being made by any credit/debit cards,
but it will process fleet and pass card accounts.
Credit Mode 1 – Demo mode The card reader will log, process, and track all
cards. All credit/debit cards are immediately
“accepted” by the reader.