Unitec Wash Select II POS Owner’s Manual - Manual (Page 129)

W A S H S E L E C T I I
Document Number: WS21002 115
Document Title: WSII Operations Manual
Figure 21. Removing Lower Housing
35. Firmly grasp the top of the housing with your fingers and pull it toward the palm of
you hand. (Be sure to keep steady pressure on the housing at all times during
removal.)
36. Slide the inner housing out of the back of the validator, revealing the belts, pulleys
and sensors. (See Figure 22)
Figure 22. Removing Lower Housing

Caution:
Do not use any petroleum solvents, scouring pads or stiff brushes for cleaning as it may
damage the bill validator. The MAGBAB requires no lubrication.