Unitec Wash Select II POS Owner’s Manual - Manual (Page 113)

W A S H S E L E C T I I
Document Number: WS21002 99
Document Title: WSII Operations Manual
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the “POS4000 Link” option is displayed. Press the (*) key to
enter.
3.
Scroll through this menu until the “Use POS4000 Names/$” option is displayed,
and then press the (*) key to enter.
4.
Press the (1) key for “YES” (enabled) or the (3) key for “NO” (disabled).