Unitec Wash Select II POS Owner’s Manual - Manual (Page 201)

W A S H S E L E C T I I
Document Number: WS21002 187
Document Title: WSII Operations Manual
Table 34. Canadian IDX Program Configuration
IDX Rotary Switch
Position
Old Style with $1
coin Diverted
New Style with $1
Coin Diverted
Number of Output
Pulses
Old Style $1
coin diverted New Style
$1 Coin
Diverted
1 Token 1 Token 1 1-12, 14-255
2 Token 2 $2 Coin 1-255 8 on Coin 2
3 Token 3 $2 Coin 1-255 8 on Coin 2
4 $2 coin $1 coin 8 1 on Coin 1
5 Quarters $1 Coin 1 1 on Coin 1
6 $1 Coin Quarters 1 1 on Coin 2

Note:
If you wish to dispense quarters instead, you will also need to disassemble the hopper
and change the wheel and guide-arm. (This is in addition to having to reprogram the
IDX). The quarter wheel and guide arm are shipped with your unit. For instructions on
how to do this, see Section 3.5.5 of the Operation manual.
E. Credit setup
If you have the credit option w/modem, you must decide whether you would like to do batch
closing and opening manually or automatically. Manual batch opening and closing gives you
the option of closing and opening batches at your own convenience, while in auto batch
opening and closing, the machine does it all automatically. In auto mode, batch
closing/opening happens once every 24 hours at 11pm every night. If you shut your machine
down before 11 pm every night, the batch closing/opening happens the next morning when
you turn the machine back on again. If, on the other hand, you do not turn the machine off,
but instea
d use either the WIU or Fault inputs to generate an “Out of Service” condition
overnight, the machine will close/open batches regardless at 11pm.
1. To Manually Open/Close Batch:
1. Go to the setup menu, by turning the setup/operate switch to setup.
2.
Go to “Misc. setup” main menu.
3.
Select the “system time” sub menu and set the time to your current standard time.
4.
Then go to the “credit systems” main menu.
5.
Go to the “credit systems” main menu in setup mode.
6.
Select “open batch”; batch should open. If batch opens, skip to step 13 below.
7.
If batch doesn’t open, cycle power to the entry stand, and try to repeat the batch
opening process.
8. If you are still having problems, check if the modem is powered. Also, check if the
modem cable is well connected. Then, repeat the process.