Unitec Wash Select II POS Owner’s Manual - Manual (Page 82)

W A S H S E L E C T I I
Document Number: WS21002 68
Document Title: WSII Operations Manual
6.
Using the Print Pager #’s or View Pager #’s function, verify that the pager slot is
“Not Used”
2.10.5 View Current Pager Numbers
This function allows you to view the configuration of each pager slot. It will show the pager’s
slot number, telephone number, pause time, PIN number and the termination character in the
wash displays.
To enter this function, follow the steps below.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the ”Paging Functions” option is displayed. Press the (*) key to
enter.
3.
Scroll through this menu until the “View Pager #” option is displayed, and then
press the (*) key to enter.
4. Use the (3) key to scroll forward to the next pager number and the (1) key to scroll
to the previous pager number.
2.10.6 Print Current Pager Numbers
This feature allows you to print pager numbers (requires the optional thermal printer). You
may use the tables above for information regarding settings for each pager type. The steps
below will help you print your pager numbers.

Note:
The voice pager number is found at the bottom of the configuration report. This is
located in the “Reporting Menu”.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2. Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the ”Paging Functions” option is displayed. Press the (*) key to
enter.
3. Sc roll through this menu until the “Print Pager #” option is displayed, and then
press the (*) key to enter.
2.10.7 Testing a Pager
Use this function to test a pager. You may send one message to a selected pager when
performing this function.