Unitec Wash Select II POS Owner’s Manual User Manual
Page 81
W A S H S E L E C T I I
Document Number:
WS21002
67
Document Title:
WSII Operations Manual
Table 10. Text (TAP) Pager Parameters
Setting
Description
Phone #
(up to 16 digits)
This is the TAP access phone number for the Paging/phone
system.
This is not the phone number for your pager or phone.
Paging Access Numbers for the access phone number to your
system.
E X A M P L E :
Skytel:
(800) 258-9880
Pin #
(up to 16 digits)
This is the PIN # of your text pager or the normal phone number of
your Cell phone equipped w/ text messaging (Sprint PCS, AT&T
PCS, Nextel)
Use the following procedure to program or edit the pager number:
1.
Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)
2.
Using the (3) key to scroll forward and the (1) key to scroll back, scroll through the
main menu until the ”Paging Functions” option is displayed. Press the (*) key to
enter.
3.
Scroll through this menu until the “Edit Pager #” option is displayed, and then
press the (*) key to enter.
4.
Enter a slot number (1-6). Press the (*) key to enter.
5.
Enter a pager type. 1 = Voice, 2 = Numeric, and 3 = Text. Press the (*) key to
enter.
6.
Enter the TAP access phone number including the area code; if it is necessary for
the modem to dial a 1 you must enter that as well. Example: 15555551212. Press
the (*) key to enter.
7.
Enter your PIN number, and then press the (*) key.
2.10.4
Disabling/Erasing Pager Slots
To disable/erase a pager slot that has already been configured, perform the following steps:
1.
Enter the “Edit Pager #” function
2.
Select the pager slot you want to disable/erase.
3.
Select Numeric, Text, or Voice.
4.
When prompted for the phone number press the * key
5.
When prompted for the PIN number press the * key