Unitec Wash Select II POS Owner’s Manual - Manual (Page 84)

W A S H S E L E C T I I
Document Number: WS21002 70
Document Title: WSII Operations Manual
S A M P L E P A G E R L O G P R I N T O U T :
2.11 Cash and Tokens Menu
This menu contains functions that affect the acceptance and/or dispensing of cash and
tokens.
2.11.1 Country Code
The country code affects the assignment of coin and bill values for each coin and bill input, as
well as which coin input is used for tokens. The Wash Select II software will support these
countries; however, hardware changes are required for the cash components to work for
different countries.
Table 11. Country Codes
Country Code Country
0 USA
1 Canada Mode 1 (Dispense $.25)
2 Canada Mode 2 (Dispense $1)
3 Australia
4 T.T. (Trinidad and Tobago)
Default : USA
2.11.2 Defining the Value of a Token
This function allows you to configure the value of the token (coin input 3 for USA), by
chan
ging the “Token Value”. This is the value that the Wash Select II will register for each
token pulse received by the token input. See Section 3.5.2 to set multiple token values if you
are using more than one type of token.
1. Using the toggle switch at the top of the CPU board, place the Wash Select II in
setup mode by moving the switch toward the back of the Wash Select II case.
(The CPU board is located on the inside right wall of the Wash Select II case.)