Sindoh N700 User Manual
Page 311
9-
27
Maintenance and Troubleshooting
9
Message
Cause
Solution
Memory is full. No
more scan job
available. Do you want
to cancel this job?
Memory used up during scan
data storing.
“Press [YES] to cancel
current job, or press [No] to
output scanned data up to the
present.
USB Memory is full. No
more scan job
available.
USB memory used up during
scan data storing.
Press [OK] to cancel current
job.
USB Check Failure
USB memory recognition failed.
Reconnect the USB memory.
Finisher Failure
Finisher cannot be used due to
Finisher error.
“Select and use not Finisher but
another Delivery to in the set-
tings. For Finisher error, contact
our Call Center.”
Cannot staple paper
of this size
Staple cannot be used with the
paper size.
Run without staple setting or
use the paper in different size.
Cannot use the
finisher
Finisher Output cannot be used
with the paper size.
Use not Finisher but another
Delivery to, or use the paper in
different size.
Use ARDF only
The feature can be used only
for the original applying the
ARDF.
Sett the original onto ARDF to
use.
This original size is
not available
The feature cannot be used for
current original size.
Use the original in different
size.
Cannot use the mixed
size mode
This original size does not
support Mixed Side Mode.
Use the original in different size
(see
Cannot use the f
inisher for this paper
type
The paper type cannot allow
Finisher Output.
Use the paper in another type
(see
Low toner
Toner is no longer of any use.
Prepare new toner.
Drum near end
PCU is no longer of any use.
Prepare the new PCU.