Memory is full – Sindoh N700 User Manual
Page 116
Copy Features
2-
40
Status
Cause
Solution
Copy is not made in order. Original position is wrong.
When setting it on the ARDF,
set the original so that the
preceding page can be laid up.
When setting on the Flatbed ,
set the original in order from
the preceding page.
[
T to T
]was set up in
2 Sided, but it is copied
by [
T to B
].
Or,[
T to B
]was set up,
but it is copied by [
T to T
].
Original position is wrong.
Set up the original position
correctly.
See
Memory is full
If the memory is full, you can output the copies up to the scanned page and end the job, or cancel
the job without copy printouts.
Status
Cause
Solution
More scanning cannot be
made due to full memory.
Do you cancel the current
job? [
YES
], [
NO
]
- When memory is full,
copying stops and
the above message
is displayed on the
screen.
Scanned original is exceeding
the quantity to be stored in the
memory.
`Output the copies up to the
scanned page and then press
[
NO
] when ending the job.
When cancelling the job
without output,Press [
YES
].