Sindoh N700 - Manual (Page 27)

11
Before use
Total Energy Use
It would be useful to calculate total energy use of the product. To calculate energy use, multiply
the power consumption by the hours consumed in each mode by the produc, as the electricity is
billed per Watt (W). Total energy use is the sum of energy use in each mode.
Dewing
If there is sharp change at ambient temperature, fine water drops may form in the inside and
outside of the Machine. Wipe off external water drops and wait until internal water drops will be
disappeared in opening the Platen Cover or the ARDF of the Machine.
EMC Notice
INFORMATION TO THE USER
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
WARNING
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This Class [A] digital apparatus complies with Canadian ICES-003.
Cet appareil num rique de la classe [A] est conforme la norme NMB-003 du Canada.
WLAN Notice
Exposure to radio frequency radiation
The following notice is applicable if your printer has a wireless network card installed.
The radiated output power of this device is far below the FCC radio frequency exposure limits.
A minimum separation of 20 cm (8 inches) must be maintained between the antenna and any
persons for this device to satisfy the RF exposure requirements of the FCC.