Metrohm NIRS XDS Process Analyzer – DirectLight/NonContact - Manual (Page 59)

▪▪▪▪▪▪▪ 57
22. This manual now describes various
software tests used to set up and test the
instrument. These tests must be run on any
sample channel marked as “Used” in the
Mux Table.
First select the channel. From the menu
bar, click on Acquire, then Select Channel.
Use the spinner to select the channel. Start
with Channel 1. When finished, proceed to
Channel 2 if used. (In most cases it is not
used.)
10.1 Configure Options
Before tests are run, the Options must be set. This determines the methods of instrument set-up, and
affects how the data will be acquired.
1. Select Configure, Options from the menu
bar.
2. The menu shown at right is the set of
selections. A brief explanation follows: