Metrohm NIRS XDS Process Analyzer – DirectLight/NonContact - Manual (Page 57)

▪▪▪▪▪▪▪ 55
16. Click on the drop-down arrow beside the Tip Type box. This shows supported types of probe
configurations. In this case, select Interactance Reflectance Probe, if that is what is being
used.
17. Click on the drop-down arrow next to Fiber Count. The XDS Single Point instrument uses
Micro Bundle. Select Micro Bundle.
Fiber Length depends on the fibers used in the system. The default is 0-3 Meters. If longer, set
as appropriate.
Scans defaults to 32 scans for a spectrum. This is normally not changed unless there is a
sampling reason that requires fewer, or more, sample scans.