Metrohm NIRS XDS Process Analyzer – DirectLight/NonContact - Manual (Page 48)

46 ▪▪▪▪▪▪▪
Slide the cable connector housing onto the RJ-45 cable
as shown.
Using the correct type of crimping tool, crimp the RJ-45
connector jack onto the cable. Be sure the conductors
are arranged in the proper order and are in the
designated positions for crimping.
Push the RJ-45 jack fully into the connector housing.
Install the locking clip as shown to hold the jack to the
connector housing.
Note that the locking clip must be oriented as shown,
with the flat center projection toward the jack. When in
place, push down fully.
Tighten the hex collar onto the connector housing. Apply
enough torque to fully compress the seal over the cable
end.
Slide the knurled collar up onto the connector housing.
The final assembly is shown.
To attach to the instrument, insert the connector jack
(tab down) into the plug on the side of the instrument.
Push until it “clicks” into place.