Metrohm NIRS XDS Process Analyzer – DirectLight/NonContact - Manual (Page 128)

126 ▪▪▪▪▪▪▪
5. Remove each fuse from the clip.
It may help to push the fuse, using a pencil
eraser, from the side shown, and then
grasp the fuse to fully remove.
Inspection of the blown fuses may provide
some information about the type of fault.
Use this information to help eliminate the
cause of the problem.
Discard old fuses immediately.
6. Install new fuses as shown. The fuses clip
into the holder, and will be retained in
position.
7. Push down the fuse door firmly until it
snaps into place. Be sure this has been
performed for both fuses.