Rockwell Automation 2707-M232P3_M485P3 DTAM Micro Operator Interface Module - Manual (Page 90)

Specifications
Appendix A
A–2
Class 1 Division 2 Groups A, B, C, D, hazardous locations
(Series B or higher)
NEMA Type 4, 12, 13 (indoor use only)
Class 1 Division 2 Groups A, B, C, D, hazardous locations
(Series D or higher)
(Series C or higher)
1
1
Series E Only – Cat. Nos. 2707–M232P3, 2707–M485P3
If this product is installed within the European Union or EFTA regions, the
following regulations apply.
!
ATTENTION: To maintain compliance with European Union
Directives there must exist at least 2.5 cm (1 in.) free air space
around the sides and back of this unit when installed in an
enclosure.
This apparatus is tested to meet Council Directive 89/336 electromagnetic
Compatibility (EMC) Standards:
•
EN50081-2 Class A (Industrial) Emissions
•
EN50082-2 Class A (Industrial) Immunity
•
EN61000–6-2 Class A (Industrial) Immunity (Series E Only)
According to these Standards, the factor which determines, for EMC
purposes, whether an apparatus is deemed to be “Industrial” or “Residential,
commercial and light industrial”, is given in Clause 1 of EN50081–2 as
follows:
Apparatus covered by this standard is not intended for connection to a
public mains network, but is intended to be connected to a power
network supplied from a high- or medium-voltage transformer dedicated
for the supply of an installation feeding a manufacturing or similar plant.
The product described in this document is intended solely for use in an
industrial environment as defined above. When installed in Europe, any other
application is in contravention of the European Union Directives, and a
breach of those laws.
Agency Ratings
European Union Directive
Compliance