Rockwell Automation 2707-M232P3_M485P3 DTAM Micro Operator Interface Module - Manual (Page 44)

Chapter 4
Transferring Applications
4–8
This section shows how to upload an application from the DTAM Micro to a
computer running DPS software (Catalog No. 2707-NP, series C or later).
Refer to the DPS User manual (Publication No. 2707-801) for additional
instructions.
1. Apply power to the DTAM Micro.
The following message appears in the window of the DTAM Micro.
Programming Mode
Waiting For Program
If you do not see this message, check the DIP switch settings.
DIP Switch position #1 must be in the Closed (ON) position.
2. On your computer, move to the /DPS subdirectory.
C:\DPS>
3. Type dps and press [Return] to start the program.
C:\DPS>dps [Return]
4. Specify whether you are using a color monitor. Enter Y or N.
5. The startup screen displays.
Voice: 440–646–6800
FAX: 440–646–6850 or 6890
E–mail: [email protected] Technical Support
Uploading an Application
. You will not see this prompt if
a monitor was specified during
installation.