Rockwell Automation 1771-CFM,D17716.5.99 CONFIGURABLE FLOWMET - Manual (Page 87)

Using I/O Configuration Software E–2
Publication 1771Ć6.5.99 - December 1995
Channel Setup Screen
1771–CFM Series A Channel Setup Rack–Group–Module: 0–0–0
channel 0 channel 1 channel 2 channel 3
current values:
channel mode high–res freq (not used) totalizer noreset totzr
frequency 43.0 15,487 258
total counts ––– 3,881,128 1,111,111
acceleration 0 359 0
–––––––––––––––––––– channel 0 channel 1 channel 2 channel 3
new channel mode high–res freq (not used) totalizer noreset totzr
minimum sample time 10 ms 1000 ms 0 = 100 ms
for frequency
acceleration 2,000 5,000 disabled
alarm value
accel sample time 100 rolling avg –––
(freq intervals)
highest allowed 60,000 0 0
frequency
Press F9(Toggle) to change channel mode.
Rem RUN mod 1 of 1 Addr#42:CFM4B
Change I/O Output Monitor BT Data Default Toggle Accept
Mode Ovrview Setup Tables Config
F1 F2 F4 F5 F6 F8 F9 F10
Cursor to
BT instruction
I/O Module
System Overview
F3 F2
Edit Channel Setup
or
a b
Output Setup
or Monitor
or BT Data
c
F2
F10
Edit
I/O Edit
or
Choose one:
Use PageUp or PageDown to move
through the channel setup screens.
Ladder Editor
Main Menu
Shows current values for each channel
(these values reflect the data received
the last time a BTR was completed).
The PLC processor must be in Run
mode if you want to receive current data
from the CFM module.
Shows current programming
for each channel and lets you
change the channel programming.
Fields inapplicable in the
programmed channel mode are
shown as dashes
and cannot be edited.
Press
(F3)
Ć
Channel Setup
to configure individual channels or
(F10)
-
Accept
to accept
your edits. We suggest that you complete your edits on all screens before accepting the edits.
–––––––––––––––––––– channel 0 channel 1 channel 2 channel 3
scalers for total ––– 1/2 1/1
(multiply/divide)
rollover value ––– 0 5,000,000
tied to outputs 0,2,3 1 none
reset total ––– disabled –––
reset overflow ––– disabled disabled
start prover ––– enabled enabled
prover type, uni ––– bi uni
or bidirectional
Enter rollover value (0 to 9,999,999).
>
Rem RUN mod 1 of 1 Addr#42:CFM4B
Change I/O Output Monitor BT Data Default Accept
Mode Ovrview Setup Tables Config
F1 F2 F4 F5 F6 F8 F10
–––––––––––––––––––– channel 0 channel 1 channel 2 channel 3
lowest measurable 1 Hz ––– –––
frequency
end sample on time only ––– –––
counts to end ––– ––– –––
sampling
frequency resolution 0.1 Hz ––– –––
frequency scalers 1/1 1/1 1/60
(multiply/divide)
Press F9(Toggle) to change bandwidth limit.
Rem RUN mod 1 of 1 Addr#42:CFM4B
Change I/O Output Monitor BT Data Default Toggle Accept
Mode Ovrview Setup Tables Config
F1 F2 F4 F5 F6 F8 F9 F10