Rockwell Automation 1771-CFM,D17716.5.99 CONFIGURABLE FLOWMET - Manual (Page 19)

Chapter
2
Publication 1771Ć6.5.99 - December 1995
Install the CFM Module
Follow the instructions in this chapter to install the CFM module.
To install the CFM module See page
Understand Compliance to European Union Directive . . . . . . 2-2
Calculate Power Requirements . . . . . . . . . . . . . . . . . . . . . . 2-3
Set the Configuration Jumpers . . . . . . . . . . . . . . . . . . . . . . . 2-3
Check the Module Operation Jumper . . . . . . . . . . . . . . . . 2-3
Set the Input Channel Jumpers . . . . . . . . . . . . . . . . . . . . 2-4
Determine CFM Module Placement . . . . . . . . . . . . . . . . . . . 2-6
Key the Backplane Connector . . . . . . . . . . . . . . . . . . . . . . . 2-6
Install the Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-7
Make Connections to the Field Wiring Arm . . . . . . . . . . . . . . 2-8
!
ATTENTION: Electrostatic discharge can damage
integrated circuits or semiconductors if you touch
backplane connector pins. Follow these guidelines
when you handle the CFM module.
•
Touch a grounded object to discharge static potential.
•
Wear an approved wrist-strap grounding device.
•
Do not touch the backplane connector or
connector pins.
•
Do not touch circuit components inside the module.
•
If available, use a static-safe work station.
•
When not in use, keep the CFM module in its
static-shield bag.
What This Chapter
Contains