Rockwell Automation 1771-CFM,D17716.5.99 CONFIGURABLE FLOWMET - Manual (Page 50)

4–16 Configure the CFM Module
Publication 1771Ć6.5.99 - December 1995
To configure the CFM module, you set the appropriate bits in the
BTW instruction. You do this:
•
through I/O Configuration software if you are using a PLC-5
family processor (see PLC-5 Programming Software I/O
Configuration Manual, publication 6200-6.4.12, for supported
processors)
or
•
by editing bits at the address of the BTW instruction
Using I/O Configuration Software
To configure the CFM module using I/O Configuration software, you
enter the appropriate information on the CFM module edit screens.
Use these documents to help you use I/O Configuration software:
publication 6200Ć6.4.12
I/O Configuration
Software Using I/O
Configuration
Software
PLCĆ5
Programming
Software
E
Setting Bits in the BTW Configuration Block
If you are not using the I/O configuration utility, edit the data file
addresses in the BTW instruction to match your particular
application. Use the word descriptions on pages 4–3 through 4–7
to help you edit the bits that apply to your application(s).
Interpret
Module Status
and Input Data
5
Configure the Module
What's Next