Rockwell Automation 1785-L20C_L40C, D17856.5.14 ControlNet PLC-5 Programmable Controllers User Manual - Manual (Page 53)

Chapter 3
Configuring Your ControlNet System
3-9
Do this: If you want to:
insert an entry or range of entries into the list 1. Move the cursor to the node where you want to add a module or message
2. Press
[F7]—Insert to List
3. Type the slot or message number (slot/message or node.slot/message) for a single new
entry or range (slot/messageĆslot/message or node.slot/messageĆslot/message) for
multiple new entries
4. Press
[Enter]
delete a module or message 1. Move the cursor to the item that you want to delete
2. Press
[F8]—Delete *
3. Press
[F8]—Delete Item
delete all modules and messages 1. Press
[F8]—Delete *
2. Press
[F10]—Delete List
go to the ControlNet I/O Action screen
Important: This option is not available if the
display mode is set to
Message Display
on this screen by using
[F3]—Select
Display
.
1. Move the cursor to the 1794 Flex I/O module entry who's actions you want to edit
2. Press
[F9]—Edit Actions
apply pending edits and return to the
ControlNet I/O Mapping (Monitor) screen
Press
[F1]—Accept Edits
return to the ControlNet I/O Mapping
(Monitor) screen without saving any
pending edits
Press
[Esc]