Rockwell Automation 1785-L20C_L40C, D17856.5.14 ControlNet PLC-5 Programmable Controllers User Manual User Manual
Page 100

Index
I–4
copying node information to a new
address,
defining local rack characteristics,
deleting a module or message,
deleting a node from the node list,
deleting all modules and messages,
deleting all nodes from the node list,
editing 1794 I/O module action,
editing ControlNet I/O mapping,
editing node information,
editing the ControlNet
nodeĆinformation configuration,
entering the length of cable between
repeaters,
entering the number of coax repeaters,
entering the number of fiberĆoptic
repeaters,
inserting an entry at an unused slot or
message address,
inserting nodes into the node list,
manually entering the amount of
information received from a
module or message,
manually entering the amount of
information sent to a module or in
a message,
manually entering the amount of
information to be stored in the I/O
configuration file for a module,
manually entering the destination file
for information received from a
module or message,
manually entering the file for storing
the I/O configuration needed for a
module,
manually entering the source file for
information sent from a module or
in a message,
matching the processor and ControlNet
configurations,
moving a node description to a new
address,
specifying the Data Input File (DIF),
specifying the Data Output File (DOF),
specifying the Default Configuration
File,
specifying the Diagnostics File,
specifying the I/O Status File,
specifying the maximum scheduled
node address,
specifying the Network Update Time
(NUT),
specifying the number of coax
repeaters,
specifying the redundancy
characteristic of the ControlNet
media,
viewing the maximum percent of
scheduled bandwidth,
viewing the number of scheduled I/O
mapĆtable entries indicating data
transfers to and from the
processor,
viewing the percent of scheduled
bandwidth used in the worst case,
viewing the percentage of the Data
Input File (DIF) being used,
viewing the percentage of the Data
Output File (DOF) being used,
configuring nodes,
locating additional information,
monitoring,
viewing a 1794 system's fault action,
viewing a 1794 system's fault action
viewing a 1794 system's idle action,
network maintenance,
network update cycle, what happens in,
scheduled operations,
setting the switches,
troubleshooting,
unscheduled operations,
using ControlNet PLCĆ5 processors in,
ControlNet WHO ACTIVEĊNetwork Status
screen, fields
Bad Frames Received,
5Ć19
Errors / 100,000 FramesĊChan A,
5Ć19
Errors / 100,000 FramesĊChan B,
5Ć19
Good Frames Received,
5Ć19
Node,
5Ć19
Total ErrorsĊChan A,
5Ć19
Total ErrorsĊChan B,
5Ć19
D
Data Input File
description,
specifying,