Control, Input/output ratings, Electrical – Rockwell Automation 1336 8A-48A Fiber Industry User Manual
Page 122
A–2
Specifications and Supplemental Information
Electrical
Input Data
Voltage Tolerance:
–10% of minimum, +10% of maximum.
Frequency Tolerance:
48-62 Hz.
Input Phases:
Three-phase input provides full rating for all drives.
Single-phase operation is possible for A & B Frame drives
at a derating of 50%.
Displacement Power Factor
A1-A3 Frame Drives:
0.80 standard, 0.95 with optional inductor.
A4 Frame & Up Drives:
0.95 standard.
Efficiency:
97.5% at rated amps, nominal line volts.
Max. Short Circuit Current Rating: 200,000A rms symmetrical, 600 volts (when used with AC
input line fuses specified in Chapter 2).
Control
Method:
Sine coded PWM with programmable carrier frequency. Ratings
apply to all drives (refer to the Derating Guidelines on page A–3).
A Frame Drives
2-10 kHz. Drive rating based on 4 kHz (see pg. 1–1 for frame info).
B Frame Drives
2-8 kHz. Drive rating based on 4 kHz (see pg. 1–1 for frame info).
Output Voltage Range:
0 to rated voltage.
Output Frequency Range:
0 to 400 Hz.
Frequency Accuracy
Digital Input:
Within
±
0.01% of set output frequency.
Analog Input:
Within
±
0.4% of maximum output frequency.
Volts per Hertz Ratio:
Fully programmable.
DC Boost:
No Boost, Auto Mode (8 settings w/programmable Run Boost re-
duction), Full Custom, Fan Mode (2), or
Fixed Mode (with independent Accel and Run Boosts).
Accel/Decel:
Two independently programmable accel & decel times. Each time
may be programmed from 0 to 6000 seconds in 0.01 second incre-
ments.
Intermittent Overload:
Constant Torque – 150% of rated output for 1 minute.
Current Limit Capability:
Proactive Current Limit programmable from 20 to 160% of rated
output current. Independently programmable proportional and in-
tegral gain.
Inverse Time Overload Cap. Class 10 protection with speed sensitive response. Investigated by
U.L. to comply with N.E.C. Article 430. U.L. File E59272, volume 4/6.
Input/Output Ratings
Note: Drive ratings are at nominal values. See Derating Guidelines
on page A–3.
Constant Torque
Cat. No.
Input kVA
Input Amps
Output kVA
Output Amps
200-240V DRIVES
AQF20
AQF50
3.9
8.5
9.7
21.3
3.2
7.2
8.0
18
A015
17-20
49
19
48
380-480V DRIVES
BRF50
BRF100
6.6-8.0
12.2-14.7
10.0
18.5
6.7
13.9
8.4
17.5
B010
B030
11-14
30-38
17
46
13
36
16.1
45