Rockwell Automation 1336 8A-48A Fiber Industry - Manual (Page 102)

5–36 Programming
This group contains a number of “Read Only” parameters that display drive operating char-
acteristics. This group will only be available with firmware versions 2.01 and above. Refer
to the “Diagnostics” group if your firmware is below 2.01.
Ratings
[Drive Type]
This parameter displays a decimal number which
can be translated into the drive catalog number by
using the adjacent chart. Refer to Chapter 1 for an
explanation of the catalog numbers.
Parameter Number 61
Parameter Type Read Only
Display 1336S– . . .
8453 AQF20
8455 AQF50
12554 A015
8711 BRF50
8713 BRF100
12809 B010
12813 B030
[Firmware Ver.]
This parameter displays the version number of the
drive firmware.
Parameter Number 71
Parameter Type Read Only
Display Units / Drive Units None / Version x 100
Display 0.00
[Drive Rtd Volts]
This parameter displays the rated input voltage of
the drive.
Parameter Number 147
Parameter Type Read Only
Display Units / Drive Units 1 Volt / Volts
Display Drive Rated Input Voltage
[Rated Amps]
This parameter displays the rated output current of
the drive.
Parameter Number 170
Parameter Type Read Only
Display Units / Drive Units 0.1 Amp / Amps x 10
Display Drive Rated Output Amps
[Rated kW]
This parameter displays the rated kW of the drive.
Parameter Number 171
Parameter Type Read Only
Display Units / Drive Units kW / kW x 100
Display Drive Rated Output kW