SATEC PM130 PLUS Manual - Manual (Page 68)

‎Chapter 5 Configuring T H E P M 1 3 0 P L U S
Configuring C O M M U N I C A T I O N S
68 PM130 PLUS Powermeter Series
Table 16: GPRS Setup Options
Parameter Default Description
Access Point Name (APN) internetg The mobile network APN name
User name Username (if required)
Password Password (if required)
2. Configure your mobile network APN, username and password.
Consult your network operator regarding proper network
settings. Leave the username and password fields blank if
network authorization is not required.
3. Send your GPRS settings to the meter.
4. Select the GPRS interface in the COM2
port setup (see Setting Up Serial
Communication Ports ).
5. Configure your eXpertPower client (see Setting Up eXpertPower
Client ) or/and TCP Notification client (see Setting Up TCP
Notification Client ) for communicating with a remote server.
You can check the status of the GPRS communications from the front
panel via the
Status Display or via the Device Control dialog in PAS (see
Viewing Communication Status and Statistics ).
Setting Up eXpertPower Client
The PM130 PLUS has an embedded eXpertPower TM client that provides
communications with the eXpertPower TM server – the SATEC proprietary
Internet services. Connections to the eXpertPower TM server are handled
on a periodic basis.
To set up communications with the eXpertPower TM server, select
Communication Setup from the Meter Setup menu, and then click on
the ExpertPower Client Setup tab.