SATEC PM130 PLUS Manual - Manual (Page 157)

‎Appendix F D A T A S C A L E S
PM130 PLUS Powermeter Series 157
Appendix F Data Scales
The maximum values for volts, amps and power in the PM130 PLUS setup
and in communications are limited by the voltage and current scale
settings. See
Device Options in Chapter 4 on how to change the voltage
and current scales in your meter.
The following table shows the meter data scales.
Table 39: Data Scales Values
Scale Conditions Range
Maximum voltage
(V max) All configurations Voltage scale  PT Ratio, V 1
Maximum current
(I max)
All configurations Current scale  CT Ratio, A 2, 3
Maximum Power 4 Wiring 4LN3, 3LN3, 3BLN3 V max  I max  3, W
Wiring 4LL3, 3LL3, 3BLL3,
3OP2, 3OP3, 3DIR2
V max  I max  2, W
Maximum frequency 25, 50 or 60 Hz 100 Hz
400Hz 500 Hz
1 The default voltage scale is 144V. The recommended voltage scale is
120V+20% = 144V for using with external PT’s, and 690V+20% = 828V
for a direct connection to power line.
2 CT Ratio = CT primary current/CT secondary current
3 The default current scale is 2  CT secondary (2.0A with 1A secondary
and 10.0A with 5A secondary).
4 Maximum power is rounded to whole kilowatts. With PT=1.0, it is
limited to 9,999,000 W.