SATEC PM130 PLUS Manual - Manual (Page 120)

‎Chapter 7 Monitoring M E T E R S Viewing R E A L - T I M E H A R M O N I C S P E C T R U M
120 PM130 PLUS Powermeter Series
The spectrum table shows voltage, current, active power and reactive
power harmonic components both in percent of the fundamental and in
natural units, and harmonic phase angles.
To change a phase, click on the window with the right mouse button,
select Options..., check the phase you want displayed, and then click OK.
Figure ‎7-5: RT Harmonic Monitor – Spectrum Table
Viewing Synthesized Waveforms
To view the synthesize waveforms based on the sampled harmonic spectrum,
click on the
button on the local toolbar to view non-overlapped voltage
and current waveforms, or click on the button to view them overlapped.
PAS shows a pair of 4-cycle voltage and current synthesized AC waveforms
for a single phase.
To select the channels you want to view, click with the right mouse button on
the waveform window, select “Channels...”, check the channels for the phase
you want displayed, and then click OK.