Panel mounting, Din rail mounting – SATEC PM130 PLUS Manual User Manual
Page 20
Chapter 2 Installation
Mechanical
I N S T A L L A T I O N
20
PM130 PLUS Powermeter Series
Panel Mounting
To mount the meter in cutout (ANSI 4" round or DIN 92x92mm
square cutout):
1. Position the meter in the cutout.
2. Affix the meter using washers and nuts. (Add short text on
Panel Mounting, a heading should always have text)
Figure 2-2. Mounting
DIN Rail Mounting
The PM130 can be mounted on a 35-mm DIN rail.
Figure 2-3. Dimensions
See also other documents in the category SATEC Equipment:
- AX-8 (15 pages)
- BFM136 (70 pages)
- C191HM (63 pages)
- C192PF8-RPR (75 pages)
- EDL175 (23 pages)
- EM132-133 Manual (152 pages)
- EM132-133 Quick Start (10 pages)
- ETC2002 (57 pages)
- EM720 Installation Manual (32 pages)
- EM720 Operation Manual (218 pages)
- EM920 Installation Manual (37 pages)
- EM920 Operation Manual (225 pages)
- SA300 ezPAC Installation Manual (43 pages)
- SA300 ezPAC Operation Manual (182 pages)
- PAS (27 pages)
- PM130 PLUS Quick Start (4 pages)
- PM135 Manual (166 pages)
- PM135 Quick Start (4 pages)
- RDM172 Manual (135 pages)
- RDM172 Quick Start-1 (10 pages)
- RDM172 Quick Start-2 (14 pages)
- PM174 Manual (149 pages)
- PM174 Quick Start (11 pages)
- PM175 Manual (168 pages)
- PTS175 Manual (12 pages)
- PM175 Quick Start (13 pages)
- PM180 Installation Manual (33 pages)
- PM180 Operation Manual (184 pages)
- RGM180 (24 pages)
- PM296 (77 pages)
- RSC232 (10 pages)
- 1771DB (17 pages)
- SLC500 (24 pages)