Lenze EMF2133IB - Manual (Page 81)

Process data transfer
PROFIdrive control
PROFIdrive status word
7
l
81 EDSMF2133IB EN 5.0
7.3.4 PROFIdrive status word
Bit Name Meaning
0 Ready to start Device status information
0 = Status lower than "READY TO START"
1 = Status at least "READY TO START"
1 Ready for
operation Device status information
0 = Status lower than "READY FOR OPERATION"
1 = Status at least "READY FOR OPERATION"
2 Operation
enabled Device status information
0 = Status lower than "OPERATION ENABLED"
1 = Status "OPERATION ENABLED"
3 Fault Device status information
0 = No fault (TRIP)
1 = Fault (TRIP) occurred
4 OFF2 Information via command OFF2
0 = Command active
1 = Command not active
5 OFF3 Information via command OFF3
0 = Command active
1 = Command not active
6 Switch−on
inhibit Device status information
0 = Status not "SWITCH−ON INHIBIT"
1 = Status "SWITCH−ON INHIBIT"
7 Warning Collective warning
0 = no warning
1 = warning
8 Reserved Always 1
9 Master
function
requested 82xx / 821x /
822x / 8200
vector Bus access right, depending on Lenze parameter "Operating mode"
(C0001)
0 = C0001 <> 3
1 = C0001 = 3
93XX
1
10 Setpoint
reached Status of the speed/frequency deviation
0 = HLG on <> HLG off
1 = RFG on = RFG off
11 Reserved 0
12 Manufacturer 82xx / 821x /
822x Not used
8200 vector /
93XX Mapping to bit C0150.B14
13 Manufacturer 82xx / 821x /
822x Not used
8200 vector Mapping to bit C0150.B15
93XX Mapping to bit C0150.B3
14 Manufacturer 82xx / 821x /
822x I
max
(current limit reached)
0 = Current limit not reached
1 = Current limit exceeded
8200 vector /
93XX Mapping to bit C0150.B2
15 Manufacturer 82xx / 821x /
822x Q min (f d < dQmin )
0 = Q min not active
1 = Q min active
8200 vector /
93XX Mapping to bit C0150.B5