Dascom 7010 Programmers Manual DMX - Manual (Page 71)

1-69
TrueType font symbol set selection
Code ySxx
Setting
S S fixed
xx Selecting symbol set
2 digits characters followed by “CR” code to end. For the details,
refer to explanation for [02] y command.
Function Selection of a TrueType font symbol set
Caution It depends on each TrueType font file for the symbol set which
becomes actually effective.
Example The following shows selection of Swedish symbol set:
Input data [02] n Sets units to inch
[02] L Starts label format mode
D11 Sets pixel size
YSSW Sets Swedish symbol set for
TrueType font
1911S5000500050P024P024ABC Sets character data "ABC" of
TrueType downloaded font
E Ends label format mode and
prints
Setting slash zero
Code z
Function Specifies numeric zero without slash.
This setting is valid for system font 0 to 6.
Caution This setting is valid within label format.
Example Input data below represents that data "0001" is printed by specifying
non-slash zero.
Input data [02] n Sets units to inch
[02] L Starts label format mode
D22 Sets pixel size
z Specifies non-slash zero
1600010000000500001 Sets data "0001" with system
font 6
E Ends label format mode and
prints