Dascom 7010 Programmers Manual DMX - Manual (Page 23)

1-21
Setting edge sensor selection
Code [02] e
Function Changes paper position detection sensor to transparent-type.
Used for detecting paper gap between label papers, die-cut paper,
notch hole for tag paper, etc. This setting is used as default.
Caution If not detected properly, check the sensor position.
Example Paper gap between label papers and notch holes for tag paper in Fig
below is detected.
Label paper gap ABCDEF
No 0001
ABCDEF
No 0002
Tag paper notch holes
Label one sheet feed
Code [02] F
Function Feeds label one sheet. The amount of feed is the length from the
bottom of the label paper to the next bottom of the label paper.
When using continuous paper, feeds paper the length currently set
([02] c nnnn).
Performed in the same way as operated from the Feed key on the
control panel.
Direction of feed
Amount of feed Paper length
[02] cnnnn
Label paper Continuous paper