Dascom 7010 Programmers Manual DMX - Manual (Page 25)

1-23
Figure
Note: Peeler option is not available for CLP-8301
Printing edited or formerly-printed format
Code [02] G
Function Prints label data for former printing or formatting.
Caution This command is effective only when label data for former printing or
formatting is left in the internal memory. If power is turned off or reset
is performed, data in the internal memory will be cleared, so this
command will not be effective.
Example Input data below represents that after ending label format printing data
"ABC" one sheet, printing for the same data is executed again with
this command [02] G.
Input data [02] n Sets units to inch system
[02] L Starts label format mode
D22 Sets pixel size
190001001000050ABC Sets character data "ABC" with smooth
font 48pt
E Ends label format mode and prints
[02] G Executes 1-sheet printing for edited
format
Peeler
A
B
Paper sensor
Print head
Ejection
Cutter
C