Dascom 7010 Programmers Manual DMX - Manual (Page 153)

1-151
Appendix 4 Specification of Switching of Control Codes
Control codes can be switched from the menu on the operation panel.
By setting to ALT mode, the system level command start code SOH (Immediate
execution command) and STX (Sequential execution command) will be
changed to the commands in the table below.
When setting ALT mode, replace the standard codes in the table below of this
command reference with the corresponding codes in ALT mode.
STD mode
(Initial setting) ALT mode
Immediate execution
command starting code in the
system level 0x01
(
SOH
)
0x5E
(
^
)
Sequential execution
command starting code in the
system level
0x02
(
STX
)
0x7E
(
~
)
Label format command for
specifying number of the
same labels printed
0x5E
(
^
)
0x40
(
@
)
*
*
Crossovers immediate execution command starting code.