Dascom 7010 Programmers Manual DMX - Manual (Page 16)

1-14
1.6.2 System Level Occasional Execution Commands
These commands are executed as soon as the printer receives them.
They begin with "STX," i.e. [02].
Setting date and time [02] A
Setting feedback character transmission validness [02] a
Date and time transmission request [02] B
Setting paper length for continuous paper [02] c
Setting two-page edit mode (double buffer) [02] d
Changing number of prints for edited format [02] E
Setting edge sensor selection [02] e
Label one sheet feed [02] F
Setting peeling (cutting) position [02] f
Printing edited or formerly-printed format [02] G
Graphics data block input command [02] I
TrueType fonts downloading command [02] i
Pause per label printing [02] J
Extension system command (printer settings) [02] KD
Extension system command (setting peeling or cutting position) [02] Kf
Setting Y-code-transmission-to-serial-port request [02] k
Specifying printing contents setting start [02] L
Setting maximum label length [02] M
Changing units from inch to metric system [02] m
Changing units from metric to inch system [02] n
Setting printing position [02] O
Paper cut [02] o
Setting dump mode start [02] P
Pause in occasional execution [02] p
Clearing all memory module contents [02] Q
Clearing memory module contents [02] q
Setting reflective paper sensor selection [02] r
Setting paper feed speed [02] S
Setting one-page edit mode (single buffer) [02] s